View cart 0
English

Complete Tool Runout CompensationToolRoom

Shop Software ToolRoom

Complete Tool Runout Compensation

SKU: PO946-0-04-0091

USD $1250.00

Online purchases not available outside US. Please proceed to get your request for quote.

ToolRoom RN34.1 Update 78.01 includes Total Tool runout measurement and compensation operation in iGrind. This is an add on to the existing Digitize Eccentric Runout operation previously used for compensations on endface operations only.The runout measurement and compensation can be on a blank or a pre-formed blank.Endface compensation is used for axial runout by digitising a single point close to the end of tool. Only endface operations are supported for this type of compensation.Total runout or full compensation will measure and compensate Radial and axial runout. This is mainly used while manufacturing and two points are digitised. One is near End of tool and the other at shank end. With the digitising results we can convert the grinding to the centerline of the blank rather than the centerline of the A-axis.

*Prerequisite is RN34.1



 
Complete Tool Runout Compensation
BrandANCA
Compatible machinesFX3Linear
FX5ELinear
FX5Linear
FX7Linear
MX5Linear
MX7Linear
TX7Linear
TXCell